The High-Voltage Coil should be 6 to 7 ohms. To check the coil set  
your volt meter to resistance; apply one meter lead to one end of the coil;  
apply the other meter end to the other end of the coil. If the coil is mounted,  
place one meter lead to each of the brown 4 inch resistors as shown (D and E).
Press the plunger of High-Voltage Relay #2. In this configuration you will  
read approximately 306 ohms. The value of 306 ohms is the summation of  
the two, 150 ohm resistors and the coil.  
 
 
 
 
 
Drawing Locations
ELECTRICAL BOX
ELECTRICAL BOX - VIEW A