This new style 1 or 20 Meg resistor

was chosen to replace the old

style carbon film resistor. The

new style resistor is wire wound

65 watts, and has a tolerance of

10%. This resistor is physically

smaller that the old carbon film.

To install this resistor use the

top mounting hole for the top

standoff; a 1/4 inch hole will

have to be drilled through the

lower panel to mount the bottom

standoff.

Lower standoff

Old 1 Meg resistor. This resistor was carbon film, 30 watts, and

had a tolerance of 10%. The length of the resistor was about 12

inches, and the diameter was about 1 inch.

Upper standoff

The set of six blue resistors was used to replace the 1 Meg or 20 Meg

while the standard resistor was unavailable from the OEM. The blue

resistor, when used for replacing the 20 Meg resistor were series paralleled

13 Meg ohms; when used for replacing the 1 meg were series paralleled 1

Meg ohm.