|
|
The High-Voltage Coil should be 6 to 7 ohms. To check the coil set | ||||||||||||||||
| your volt meter to resistance; apply one meter lead to one end of the coil; | |||||||||||||||||
| apply the other meter end to the other end of the coil. If the coil is mounted, | |||||||||||||||||
| place one meter lead to each of the brown 4 inch resistors as shown (D and E). | |||||||||||||||||
| Press the plunger of High-Voltage Relay #2. In this configuration you will | |||||||||||||||||
| read approximately 306 ohms. The value of 306 ohms is the summation of | |||||||||||||||||
| the two, 150 ohm resistors and the coil. | |||||||||||||||||
| Drawing Locations | |||||||||||||||||
| ELECTRICAL BOX | |||||||||||||||||
| ELECTRICAL BOX - VIEW A | |||||||||||||||||